CyberAir CW and DX

Chilled Water (CW)

• All EC Fans mounted in the cabinet meet full performance without having to be dropped into the raised floor.
• Fewer units at higher capacity can significantly reduce capital cost and operating cost
• Filter Plenums designed with increased surface area for filtration, lower pressure drop, and improved energy savings - used for large CyberAir CW units or capacity.

Direct Expansion (DX)

• DX Systems provided with highly efficient and reliable low noise scroll compressors
• Optimized AWS. Free-cooling capacities, increasing energy savings opportunities
• Hot gas reheat- provides reheat using recycled compressor heat
• Electronic expansion valves can be optimized to control a wide range of conditions
• EC fans are mounted within the unit cabinet, eliminating the need for fans to be dropped into the raised floor.

Chilled Water (CW)

• Greater airflow than other solutions
• 100% front access on all sizes
• Multiple EC Fan options 
• 2x CW valves standard on CFD-510 and larger units (option for 1 CW valve)
• Dehumidification efficiently achieved through reduced air volume at maximum cooling
• Standard and seismic floor stand available for all CW units
• Filter plenums designed with increased surface area for filtrations, lower pressure drop, and improved energy savings
• Standard MERV 8 filters (Optional MERV 11 filters)
• Highest capacity CRAHs allow for up to 1 MW of cooling capacity
• Available in multiple airflow patterns: upflow, downflow, and downflow with front discharge
• Versatile E2 controller with a range of BMS interface options
• Designed & Manufactured in the USA

Direct Expansion (DX)

• DX systems provided with highly efficient and reliable low noise scroll compressors
• Micro plate heat exchangers offer major improvements in heat transfer
• Refrigeration-based dehumidification system effectively removes excess moisture
• Modulating hot gas bypass valve for more precise low load capacity modulation and evaporator coil freeze protection
• Multi stages of DX cooling to match load requirement
• 2-stage cooling standard, with optional 4-stage cooling using tandem compressors on select models.
• Versatile E2 controller with a range of BMS interface options
• Standard and seismic rated floor stands available
• Designed & Manufactured in the USA

Technical data is subject to change without notice.